Lone Wolf Harp Octave
A distortion pedal that cuts through the mix and reduces feedback!
$289.00
$239.00
You Save $50.00
Qty
Enter your e-mail address to be notified when product is in stock
Notify Me!
Product Description
ABOUT
The Harp Octave is a great tool for the harp player who wants to have diverse sounds. It is a clean octave-up generator in the sense that it adds no solid state distortion; but what it does add are octave-up overtones that manifest itself in the mid-range with a rasp that brings out whatever distortion is going on with the amp. The end result is a raspy/crunchy distortion that can be mild or intense, according to the settings chosen. This pedal is best when using the pucker, lip block, and tongue block techniques. If you've ever wanted your big amp to sound like a nasty little vintage Champ or Princeton, this is the pedal that'll do it. The effect will really cut through the mix and reduce feedback; you will get more volume out of your amp before feedback than ever before. The Harp Octave has a buffered input, true bypass, a BLEND control, and a VOLUME control. The BLEND control increases or decreases the level of the generated octave, and the VOLUME control allows you to have more control over your volume for solos and when playing into a PA. The buffered input provides the high impedance termination necessary to get the best tone from crystal, CM, and CR elements; the output is also high impedance and plugs straight into your amp. The battery is switched OFF when an external power supply is used. The LED is ON when the effect is in, and is OFF when the effect is in bypass. The "IN" jack serves as the ON/OFF switch, so the pedal cannot be accidentally turned ON and run your battery down. The Harp Octave offers all of this and a money-back guarantee if you are not satisfied for any reason. 

SETTINGS
The settings are very basic. When the BLEND control is fully counterclockwise only the dry signal is heard, and as you turn the control clockwise the octave will increase in level until it is at the same level as the dry signal. The VOLUME control sets your output level, which does have a small amount of gain for increasing the volume when desired. A 10 to 11 o'clock setting is great for a vintage amp distortion sound. 

POWER
The pedal can be powered with a 9V battery or a DC adapter. The DC adapter requirements are a regulated 9V DC with a minimum 100mA output and a 2.1mm x 5.5mm connector with a negative center. The battery is switched OFF when an external power adapter is used, and the "IN" jack acts as the pedal ON/OFF switch. 
  1. BLEND control
  2. VOLUME control
  3. Absolutely no tone loss
  4. 9V battery power
  5. 9V DC input (barrel with a negative center)
  6. True bypass with LED indicator
  7. High impedance input
  8. Reverse polarity protection
Reviews (0)
Currently there are no reviews for this product.
Questions
Currently there are no questions for this product.
Shopping Cart
Your basket is empty